Wire Wrapping Qualification Equipment
Terminal Holding Fixture | Pull Test Gauges | Unwrap Test Tool | Test Wire
Terminal Holding Fixture
| Part No. | Description |
| QF601 | Terminal holding fixture with manual clamping |
| QF602 | Terminal holding fixture with air clamping |
| Qualification and inspection of wire wrapped connections, require the use of a terminal holding fixture. This fixture is available in two models, manual clamping (shown above) and air clamping. These fixtures will hold all standard terminals from .025” to 0.90” requiring only a simple adjustment. |  |
Back to top
Pull Test Gauges
QT15 Pull Test Gauge Is Furnished With Two Replacement Tips:
| Part No. | Description |
| QT15 | Pull Test Gauge With Two Tips |
| QT15-025 | For .025”-.032” Terminal Width |
| QT15-045 | For .039”-.046” Terminal Width |
|
The model QT15 pull test gauge accurately measures the force required to strip a wire off its terminal. Minimum strip force values are shown on the chart. It measures the force to an accuracy of 0.5% of full scale. It will retain the reading of the strip off force on the dial until released by the thumb slide switch. The tool is supplied in a sturdy protective case. Range:0-14 Kg (100gm per dial division) Tool Weight: 1 lb Tool Length: 9.5” |
 |
Back to top
Unwrap Test Tool
|
|
Test Wire
| Part No. | Wire Size | "Shiner” Length of Stripped Wire |  |
||
| AWG | MM | Inches | MM | ||
| QW 22 | 22ga | 0.65 | 1 7/16” | 36.5mm | |
| QW 24 | 24ga | 0.50 | 1 7/16” | 36.5mm | |
| QW 26 | 26ga | 0.40 | 1 13/16” | 46.0mm | |
| QW 28 | 28ga | 0.32 | 1 1/8” | 28.6mm | |
| QW 30 | 30ga | 0.25 | 7/8” | 22.2mm | |
|
500 wires per package |
|||||
Back to top